1. The position of a point can be fixed more accurately by
2. Number of links in a 30m metric chain is
3. The number of horizontal cross wires of a stadia diaphragm is
4. In a closed traverse, the sum of south latitudes exceeds the sum of north latitudes and the sum of east departures exceeds the sum of west departures. The closing line will lie in the
5. The longitudinal section of surface of a bubble tube is
6. The initial setting time of cement is caused by formation of
7. The constituent responsible for strength in granite is
8. The loss of ignition of cement should not exceed
9. The constituents of cement, which acts as binder are
10. A badly mixed cement concrete results in
11. Material generally not used as extender in paint is
12. The designation of sheet size 594x841 is
13. The main ingredients of pencil leads are
14. Generally height of letters in in drawing sheet is
15. The dotted line represents
16. Value of eccentricity of parabola is
17. Residual soils are formed by
18. A fully saturated soil is said to be
19. The maximum number of steps in a flight should generally be restricted to
20. Which of the following mortar is most suitable for construction work in water logged areas?
21. As compared to stretcher course, the thickness of joints in header course should be
22. The practical limit of moisture content achieved in air drying of timber is
24. Turbidity is measured in
25. The maximum discharge of a tube well is about
26. The suitable layout of distribution system of city with road of rectangular pattern is
27. The type of valve which is provided to control the flow of water in the distribution system at street corners and where the pipe lines intersects is
28. In canal siphon, flow is
29. Vertical drop fall is satisfactory for a drop upto
30. The most desirable alignment of an irrigation canal is along
31. Shaft spillyway is the same as
32. The maximum design gradient for vertical profile of a road is
33. The type of transitional curve provided on hill trace is
34. The total reaction time for an average driver for normal situation is
35. In gravel road the binding material used is
36. Longitudinal joints in concrete roads are provided if the width exceeds
38. In case of gravel road pot hole maintenance comes under the maintenance of
39. Bitumen is soluble in
40. During calculation the amount of steel deducted is
41. An area of 1 hectare is equal to
42. Contractor profit is added to
43. Full payment of contractor is done
44. The amount of money deposited along with the submission of tender is known as
45. Which of the following is known as general overhead?
46. The full form of VAT is
47. Which of the following is not an essential part of general specification of public works?
48. The probability of completion of any activity within its expected time in PERT is
49. Bar chart is drawn for
50. Gantt chart is drawn for
Note:- Question solution Discussion will be done on our official youtube channel :-@engineering adda 72 today at 8PM {support us on youtube}
https://www.youtube.com/live/den1B6hnMG4?feature=share
