PSC LOKSEWA -1 ,KOSHI

1.The main object of running tie line is

2. Benchmark is established by

3. Overturing of vehicles on a curve can be avoided by

4. A series of closely spaced contour represents.

5. The main ingredients of Portland cement are.

6. The stone suitable for rubble masonry should be

7. The minimum numbers of steps in a flight should not be less than

8. Paints with white lead are suitable for painting of

9. Shear stress on principal plane is

10. Laminated springs are subjected to

11. A long column has maximum crippling load when its

12. The maximum shear stress occurs at

13. The discharge over broad crested weir is maximum when the depth of flow is

14. For maximum discharge in a circular channel section, the ratio of the depth of the flow to that of diameter is

15. The Froude number is the ratio of inertia force to

16. An independent mass of fluid doesnot posses

17. If the plasticity of a soil mass is zero, the soil is

18. Phreatic line in an earthen dam is

19. The coefficient of active earth pressure for a loose sand having an angle of internal friction is 300 is

20. The effective size of particle of soil is given by

21. The maximum diameter of bars in a beam is limited to

22. A flat slab is supported

23. Main reinforcement in beam is used for

24. Surface vibrator is only effective when thickness of concrete does not exceed

25. The thickened portion of masonry wall is called

26. When DPC is to be laid over large areas, the material preferred is

27. Cement used for resisting of acid is

28. The roof preferred for large span is

29. The maximum discharge of a tube well is about

30. On standard silica scale , the turbidity in drinking water should be limited to

31. The effect of increasing diameter of sewer on the self cleansing velocity is

32. Standard BOD is measured at

33. Hydrograph is the graphical representation of

34. The major resisting force of gravity dam is

35. The elementary profile of dam is

36. A straight glacis type fall with a baffle platform and baffle wall is called

37. If the RL of a canal bed and HFL of drainage are 212m and 210m respectively, then cross drainage work will be

38. Silt excluders are constructed on the

39. Compared to a level surface, on a descending gradient the stopping sight distance is

40. Which of the following shapes is preferred in a valley curve?

41. Dead slow is a

42. The maximum allowable Los Angeles abrasion value of high quality surface course is

43. For sandy soil the most common method of stabilization is

44. The penetration test on bitumen is used for determining its

45. Volume is measured correct to the nearest

46. Normally which one contract gives the maximum value of project

47. Slack time refers to

48. The time with which direct cost does not reduced with increase in time is known as

49. How many total members are there in National Women Commission including the chairperson?

50. भवन निर्माणगर्ने अनुमतिको लागि निबेदन परेको कति दिन भित्र प्रमुख प्रससिकीय अधिकृत कारवाही गरिसक्नुपर्छ