1. A discrepancy is the difference between ,
2. Methods most suitable for plotting in hilly area are
3. The contour line merge or across one another on the map in case of
4. Chainage is the distance
5. Standard size of brick as per Indian standard is
6. The Raw materials which gives desired colour in paints is:
8. Unit weight of R.C.C Concrete is:
9. Which of the following is dimension less ?
10. When the cantilever beam is loaded at its free end, the maximum tensile strength shall developed at
11. If the shear force along a section of a beam is zero, the bending moment at the section is
12. The shape of the bending moment diagram over the length of a beam, carrying a uniformly distributed load is always
13. A pitot tube is used to measure
14. If the volume of a liquid weighing 3000 kg is 4 cubic meter, 0.75 is its
15. Bernoulli's equations assume that
16. The side slope of cipolletti weir is generally kept
17. Queen closer may be placed
18. The foundation in which a cantilever beam is provided to join two footing, is known as
19. The under surface of an arch, is called
20. Black cotton soli is unsuitable for foundation because its
21. Young modulus of concrete (According to IS:450:2000) is;
22. According to Nepal Standard minimum diameter of reinforcement in a column shall not be less than
23. Column fails by crushing is;
24. The minimum length of bar which must be embedded in concrete beyond any section any section to develop the bond is
25. The cement sand mortar prefer in half brick wall is;
26. Orinamental projection from the face of the brick wall is called
27. Curing of pavement floor and slabs is done by ;
28. Slump used for beam and column
29. Source of water in mountain is;
30. Water supply pipe line should be tested at a specified pressure from;
31. Hydraulic jump occurs when:
32. Most used coagulant is
33. As the coefficient of friction increasing, the velocity in water canal
34. The shaped of lined canal is recommended by ISI is;
35. Which of the following is the mannings formula
36. In an ogee shaped spillway, the discharge is proportional to
37. Traffic surveys are carried out
38. According to the Nepal Road Standard 2070, the right of way of nation highway should not be less than
39. According to NRS 2070, the design speed of class I road in plain terrain should be
40. The minimum superelevation in rolling terrain in plains, is limited to
41. Excessive camber on road surface may causes
42. Mostly used road in Nepal
43. The rate of rise and fall along the road alignment, is called
44. Minimum radius of horizontal curve in hills roads is
45. Unit of measurements of cribbing is ;
46. Center line methods of estimation is adopted specially for
47. Aggregate planning is the planning of
48. The main responsibility of civil sub engineer is ;
49. According to ICAO all marking on the runways are painted white and taxiways are
50. Beaufort scales are used to determine
